Korg Forums

All these stands look very funky but I just find Volcas easiest to work with when they're flat.

I bought a four tier angled wooden Volca Rack and they look very funky in the studio, but I found the angle of the Volcas and the mass of cables that built up made it difficult to work with them. So I ...

It would be so useful to be able to see the current preset's value for each parameter in the display - eg with the Volca Kick there is a dot by the preset's parameter value when the dial reaches it.
...

On the Volca Drum if you accidentally press save instead of load and overwrite an important preset all is not lost:
1. Remove batteries (or one battery).
2. Pull out the power cord without shutting ...

It would be so useful to be able to see the current preset's value for each parameter in the display - eg with the Volca Kick there is a dot by the preset's parameter value when the dial reaches it.
...

Thanks, really good of you to share this!

Cheers for this!
You're Welcome

I've made a pdf of delay settings using the Volca Drums' Wave Guide Tune parameter. It can be downloaded here: https://prodrumteacher.co.uk/resources/Volca-Drum-Delay-Settings.pdf

Is there a way to set this up so the SQ-1 just sends Sync to the Drum without playing any of the Drum's parts?
Yes - just have the SQ1 set to any MIDI channel that is not being used by the Volca Drum ...

Sync does not contain a start/stop message. If you wish to start both your units by pressing play on the master unit, you need to connect them via the MIDI connector.
Ah, thank you. I guess he must b ...

Here he has Volca Beats and SQ-1 synced.
He is cabling Sync Out on Volca Beats to Sync In on Sq-1.
When I try this with Volca Drum and SQ-1 nothing happens on SQ-1 when I start Volca Drum.
I have t ...

I have the SQ-1 running with Logic. As it stands, connected via USB, the SQ-1 will only start if Logic's song position is from bar 1. And it will not loop - ie if Logic's cycle is on the SQ-1 stops af ...

I am selling my Wavedrum WD-X on eBay. It's in very good condition, having had home use only. There's a little bit of wear and tear in the centre of the head where it's been played (can be seen in th ...

Yes, I think that's what you're experiencing. The transducer (located beneath the Korg logo plate) is likely picking up the sound of anything that makes contact with the head. Not sure if there's any ...

I found out , that its not a tuning by velocity.

The sound kind of locks to a certain pitch
until the strike is higher than a certain value ,
then it changes pitch again and stays there .

Tha ...