Korg Forums

Is there a different way that songs work inside a Set list slot compared to a combi put in a Set list slot? or am I doing something else wrong here?

Yes, song MIDI (anything that comes from interna ...

If Kronos is the only source of sound, then go straight from Out to monitor, you need 1/4" TRS cables.
If you want to play Kronos along with some other audio source then use mixer. It is not go ...

Just my 2c to offer:
Have Kronos X may years, had several times (couple times a year when I moved my Kronos around weekly, less later whan I settled it to studio) similar hangup message or just nasty ...

It was 71v.....
I also checked the connection at the power supply where the 4 wires connect to it. Guess I needed more light to see the purple wire different from the black. It is not 5 volts unless ...

ok, well, #1gives me 5v when powered on, but not off. #3 well, that number seemed outlandish. I also checked the digital out board- but it is getting the correct voltage. Is it possible to have a bad ...

ok- when I connect to the ground and the collector of the q606 when it is turned of- it measures under 1 volt. .017 to be exact.
When I turn it on it measures 3.9 at the collector. switching the el ...

Well, when I check it in diode mode, it shows the short. when I turn it on. When I check the voltage, it comes up with really strange numbers. Flip the multimeter and it shows the same only negative. ...

Do you mean measure it at that connector when it's plugged in or remove it to see what voltage it is getting?
Also- how did you get a pic on the forum? Smile

1) Yes, you should measure voltages while ...

Looks like we have 0 when plugged in but not turned on and then +5.03 like we should and it goes to 11.99 for the 12v at the 12v connection on 3005. Is there enough of a tolerance for that? I will che ...

You mentioned the 3005. That is the digital out board. The audio jack is 3006. Is that a typo or does the digital out transmit to the audio out? Which I suppose would make sense.. Just want to clarify ...

1) You cannot check that without opening keyboard. If you have valid warranty and reasonable ways to get your board repaired under warranty, go there.
2) If you want do it yourself and on your own re ...

If ALL outputs behave similarly (including headphones, L/R, Individual 1-4) then issue is probably on Jack board (KLM 3005).
This can be related to "Mute All" functionality that mutes (kind ...

Any thoughts on SPDIF vs. USB?
They both give you 24bit/48kHz sample rate signal. Futher depends on external gear you use.

Please explain bit more:
- What NI controllers you use?
- What do you mean by "In case I receive a certain controller message on a certain channel"
- Who is this "I&quo ...

As Kronos Parameter guide p781 goes: "In Combination mode, data will be transmitted simultaneously on the global MIDI channel and on the MIDI channels of timbres whose Status (Combination 0–1b, 2 ...