Korg Forums

Welcome to the forum.

When you say the settings are not overwritten by a Factory Reset, what happens, exactly? Is there an error message?

Did the seller mention that there were issues with th ...

The layer balance can be adjusted in Function Mode.

Press the Function button, then select E.Piano1, and use the + and - butttons to select the relative level. The numeric display indicates the r ...

If there is a decent hardware store near you, they might be willing to help find the correct screws. It might be worth going to the store and taking the two middle bars from the stand with you, toget ...

One way to enable selective Timbre fading in a Combi, is to go to the Global Controllers tab, and set Foot Pedal Assign to CC#18 and, in the MIDI CC# Assign section on the same page, set X-Y control Y ...

Are both of the Radias' Main Outputs, L/mono and R being used?

If the destination is a stereo mixer, are the two mixer channels being used panned hard left and right, respectively?

The Radias' ...

Maybe you found a bug. Which begs the question, is it repeatable?

.

Sequencer Memory Status is displayed as a 3 digit integer value, so it's 55%. The value displayed is for the sequencer memory that is used by the currently loaded songs.

.

This might be of use:

https://app.box.com/s/8j00ytkz9hcu4ld75snlmucp4tona2eh

.

At 2:09 in the video, there is still dialogue from the presenter. There is no music being played at that point.

.

It could be that a system restore is necessary, using the Restore disk in a USB-DVD drive.

.

Disconnect any USB storage devices from the Nautilus before powering it up. Also, disconnect any MIDI cables, either DIN MIDI, or USB MIDI.

.

Use two standard MIDI cables to connect the MIDI Out on each keyboard to the MIDI In of the other, and see what happens.

.

If you mean the 4-way connector from the mains power supply was connected to the aftertouch board, then that would have frazzled the aftertouch board, since the 4-way connector from the power supply i ...

The IEC mains power connector on the Triton Classic doesn't have a special specification that's unique to the Triton. Just about any IEC mains cable will do the job quite satisfactorily, without any ...

It could be a phasing issue. How are the HS8 speakers connected to the Pa5X? Have you connected one HS8 to the Pa5X Left Output jack, and the other HS8 to the Pa5X Right Output jack? Are the audio ...