Korg Forums

soundsailer · Full Member Joined: 29 Nov 2004 Posts: 188 Location: USA

can't seem to figure this one out, but no matter what I've tried when I record a stereo HDR track in the seq. it always plays back on the left side only......................
No issues with MIDI
_________________
Don't get caught in the spot light & don't forget to rock the boat - just don't tip it over

RonF · Posted: Thu Jul 21, 2011 12:00 am Post subject:

have you latched the tracks together as a stereo pair?
_________________
http://soundcloud.com/ronf-3/sets/ronf-music
https://www.youtube.com/channel/UCr1zAKpV_F226LQZrUYGPQA
Favorite Gear: Kronos 61, M3, Z1, Radias, KPro, KP3, Moog Voyager, Foogers, Virus TI, Jupiter 80, Integra7, GAIA, SPD-30, Kiwi 106, RE-201, MC808, RC505, MV8800, DSI P6 and OB6 and P12, Ensoniq SQ80, EMU MP-7, Eventide H7600, Eclipse, SPACE, Pitchfactor, Timefactor, Looperlative LP-1, Axe FX Ultra, Nord Modular, DSI Tetra, Tempest, PEK, JDXA, Eurorack Modular, Octatrack, MDUW, Monomachine, A4, RYTM, Waldorf Q Phoenix, MWXTk, Blofeld, TR8.

soundsailer · Full Member Joined: 29 Nov 2004 Posts: 188 Location: USA

danatkorg · Posted: Thu Jul 21, 2011 12:33 am Post subject:

RonF · Posted: Thu Jul 21, 2011 12:39 am Post subject:

Ok, well its odd, in your description you indicate you are hearing audio only on the left side on playback. So this is not "mono", per se. It sounds more like a routing issue.....as in, your tracks are not routed to the L/R buss....but rather to the "L" buss only (assuming you are not using the extra output jacks). Be sure to check your routing....also in effects, to be sure your signal is landing on the L/R buss.

I will take it for granted that:

1. You have the tracks panned hard left/right.
2. Your input was in stereo (both the hardware connection, read: stereo cables attached and functioning properly; and the software input is routed to a L/R buss, and panned as such, and then selected as the Rec Source of the tracks you record to).

But, based solely on your comment about all audio appearing at the Left channel only on playback.....I'm betting your tracks are routed to a single buss rather than a stereo buss.

Routing can be a fairly complex thing (multiple options to achieve similar results)....so lets start with this and see where we go.
_________________
http://soundcloud.com/ronf-3/sets/ronf-music
https://www.youtube.com/channel/UCr1zAKpV_F226LQZrUYGPQA
Favorite Gear: Kronos 61, M3, Z1, Radias, KPro, KP3, Moog Voyager, Foogers, Virus TI, Jupiter 80, Integra7, GAIA, SPD-30, Kiwi 106, RE-201, MC808, RC505, MV8800, DSI P6 and OB6 and P12, Ensoniq SQ80, EMU MP-7, Eventide H7600, Eclipse, SPACE, Pitchfactor, Timefactor, Looperlative LP-1, Axe FX Ultra, Nord Modular, DSI Tetra, Tempest, PEK, JDXA, Eurorack Modular, Octatrack, MDUW, Monomachine, A4, RYTM, Waldorf Q Phoenix, MWXTk, Blofeld, TR8.

soundsailer · Full Member Joined: 29 Nov 2004 Posts: 188 Location: USA

RonF · Posted: Thu Jul 21, 2011 12:50 am Post subject:

Try this.....Assuming you recorded on tracks 1 and 2. Deselect any latching/pairing of these tracks. Bring the fader down to zero (or mute) track 2. Make sure track one is assigned to L/R master buss. Put on some headphones or listen carefully while you sweep the pan of track-1 as it plays.....do you hear the track audio panning from left to right as you control the pan "pot"?
_________________
http://soundcloud.com/ronf-3/sets/ronf-music
https://www.youtube.com/channel/UCr1zAKpV_F226LQZrUYGPQA
Favorite Gear: Kronos 61, M3, Z1, Radias, KPro, KP3, Moog Voyager, Foogers, Virus TI, Jupiter 80, Integra7, GAIA, SPD-30, Kiwi 106, RE-201, MC808, RC505, MV8800, DSI P6 and OB6 and P12, Ensoniq SQ80, EMU MP-7, Eventide H7600, Eclipse, SPACE, Pitchfactor, Timefactor, Looperlative LP-1, Axe FX Ultra, Nord Modular, DSI Tetra, Tempest, PEK, JDXA, Eurorack Modular, Octatrack, MDUW, Monomachine, A4, RYTM, Waldorf Q Phoenix, MWXTk, Blofeld, TR8.