Korg Forums

britkeys

Hi anyone worked out how to keep the Timps rolling after recording into sequencer? I used ch15, got the patch F116 loaded, pressed SW2. Copied all FX used, recorded rolling into sequencer, but when I switch to another midi channel, it forgets SW2 was used, and I just get one hit at the start of measure, rather rolling timps for 4 beats.
Anyone know how to keep the rolling timps going?

britkeys · Posted: Wed Nov 09, 2011 5:02 pm Post subject:

Thought I'd sorted it by copying all effects, but still not rolling.

How would you go about recording rolling timps in sequence mode? Have you done it successfully?

Lou · Posted: Wed Nov 09, 2011 5:25 pm Post subject:

Try overdubbing the switch 2. Put the sequencer in Overdub, record the switch parameter on the same track,
then check/edit it, and make sure the switch is on, or just before the key press.
_________________
Lou

RonF · Posted: Wed Nov 09, 2011 10:21 pm Post subject:

or, conversely, load up the program, press switch 2, *save the program*, Done.
_________________
http://soundcloud.com/ronf-3/sets/ronf-music
https://www.youtube.com/channel/UCr1zAKpV_F226LQZrUYGPQA
Favorite Gear: Kronos 61, M3, Z1, Radias, KPro, KP3, Moog Voyager, Foogers, Virus TI, Jupiter 80, Integra7, GAIA, SPD-30, Kiwi 106, RE-201, MC808, RC505, MV8800, DSI P6 and OB6 and P12, Ensoniq SQ80, EMU MP-7, Eventide H7600, Eclipse, SPACE, Pitchfactor, Timefactor, Looperlative LP-1, Axe FX Ultra, Nord Modular, DSI Tetra, Tempest, PEK, JDXA, Eurorack Modular, Octatrack, MDUW, Monomachine, A4, RYTM, Waldorf Q Phoenix, MWXTk, Blofeld, TR8.

Lou · Posted: Thu Nov 10, 2011 1:33 am Post subject: