Korg Forums

[tpantano]

The file is here- http://dl.dropbox.com/u/1715217/sampleloop.wav

Once the low pass filter completely opens, I want to have a nice and booming sub-bass appear underneath. However, whenever I try and add one at the volume I want, the master volume immediately goes over 0,0 dB and clips.

I end up having to lower the sub bass to around -20 dB to prevent clipping and leave room for other instruments, to a point where you can't really hear it at all.

I have tried opening up that synth loop in an EQ analyzer and looking at it- it doesn't appear to have much below the 120 hz range once the filter's fully open, but for safekeeping I've even tried cutting the low-shelf- yet I still can't get the subbass under there.

Any ideas on how I could get a sub properly in there?
_________________
Current: MS-20 Mini, Minilogue, SY77
Past: Korg R3, Volca Bass, X50, Mg Slim Phatty, Rld Gaia SH-01, Yamaha TX81Z
Have my freebie granular plug-in: https://www.muffwiggler.com/forum/viewtopic.php?t=192886