Korg Forums

[dandriver]

hello,
i can not find an information on this, but I hope someone here can give me an answer:
Is it possible to switch or trigger the different patterns via midi messages (sysex or notes)?
Thanks a lot!

[Domguitare]

Hello,
You can find your answer (if yet usefull) p44/45/46 of the manual...
just short but I hope helpfull...
bye

[Domguitare]

2nd answer :
You can chain 3 CC :

1) CC98 ch* 01
(CC98 → LSB, ch → midi chanel and "01" = Value of CC98) (p46 of the manual...)

2) CC99 ch* 32
(CC99 → MSB, ch → midi chanel and "32" = Value of CC99)

3) CC06 ch* 1 à 127
CC06 → parameter value, ch → midi chanel and "1 à 127" = Value for selectioning MS patterns

(p46 of the manual, there is a chart to map value and the numbers of the patterns . Because values can be from 1 to 127 and there is only 16 patterns...)

So you need a footswitch that can chain these 3 CC, if not, you could buy a "MIDI Solution Event processor" (maybe it makes the price of a pattern a little expensive...)
bye
Dominique

[feedbacker2]

So these 3 messages need to be sent at the same time ? or can you send them one at a time...I suppose the latter

[Domguitare]

As you want (or as you can). You only have to send CC98 & CC99 once and then you can send several CC06, until you send an other CC for an other midi gear for example, you don't need to send CC99 & CC98 each time.