|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
vadevale
Joined: 10 Jan 2015 Posts: 2
|
Posted: Sat Jan 10, 2015 4:04 am Post subject: sp250 korg problem, volume to zero, right speaker sounds. |
|
|
hallo
I have my sp250 korg stage piano since 2007 an i am very satisfied but
recently i perceived that, during playing, by sliding the master volume potentiometer to the left end (zero), the right speaker still sounds.
Sliding to the right (increasing the sound) and about at 15% of the total length of potentiometer, the left speaker starts to sound too and the sound inreases progressively from both speakers.
The same results when using headphones instead of speakers.
In the past, when master volume potentiometer was set to zero there was, normally, no sound from both speakers .
I tried, by POWER ON while pressing both [REVERB] and [TRANSPOSE], to enter TEST MODE and the result is that E.PIANO2 LED flashing.
Any suggestion?
Thank you. |
|
Back to top |
|
|
vadevale
Joined: 10 Jan 2015 Posts: 2
|
Posted: Wed Apr 08, 2015 7:36 pm Post subject: at least i found the solution |
|
|
The hole problem was that the slide potentiometer was internally dirty. I clean it with a small cotton batonette and glass cleaning spray, an everything is all right. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|