|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
trehune
Joined: 14 Dec 2015 Posts: 1
|
Posted: Mon Dec 14, 2015 8:50 am Post subject: Automator script to reset FWAudio (Zero4/8) |
|
|
Sometimes when I connect the Zero 8 to my Mac running Yosemite or El Capitan, the audio interface does not work. As a workaround I usually disconnect/connect the firewire cable. But I eventually got tired of doing that, so after some research I found out that you can unload/load the drivers from command line, which essentially is that same as removing the cable.
I created a Automator script that unloads/loads the driver:
----snip----
on run {input, parameters}
do shell script "sudo kextunload /System/Library/Extensions/AppleFWAudio.kext" with administrator privileges
do shell script "sudo kextload /System/Library/Extensions/AppleFWAudio.kext" with administrator privileges
return input
end run
----snip----
Hope this helps someone experiencing the same problems.
/T |
|
Back to top |
|
|
ahlynsky
Joined: 27 Mar 2016 Posts: 2
|
Posted: Sun Mar 27, 2016 11:14 pm Post subject: |
|
|
Zero 8 just wont work with el capitan 10.11.3 do you have any luck with this? Is it possible because im about ready to give up. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|