Korg Forums

[EJ2]

Greetings all,
I haven't used my M3 73 in quite sometime. However, while recently checking out some of my combination designs I noticed that the touch screen was unresponsive. Yet, the XY functions work perfectly. The display is clear and correct, but since the screen is unresponsive, I cannot do a calibration from the drop down menus. Any ideas or suggestions???
_________________
Cheers,
Jim (aka EJ2) Karma-Lab Associate Combi Developer

CATALYST v 2 Blast of Inspiration for KRONOS & OASYS: http://www.karma-lab.com/sounds/catalyst2.html
CATALYST v 1 Combi Explosion for KRONOS, OASYS, M3, & K-M50: http://www.karma-lab.com/sounds/catalyst1.html
CHEMISTRY 3, a Groove Injection for Your Karma: http://www.karma-lab.com/sounds/chem3.html
SoundCloud MP3 Demoshttps://soundcloud.com/ej2-sc

[Bald Eagle]

Go to Global mode. Hold the Enter key and press 4. This should open the screen calibration page. If the calibration is not to bad you should be able to recalibrate at that point. But if the touch screen is near death the calibration may not be possible.

This worked for me for a while but the screen eventually got so bad that it did have to be replaced.

[EJ2]

Thanks, Bald Eagle. It's now packed up for my annual migration south to Florida for the winter. I'll check that routine out once I unpack. In all likelihood, I'm going to put it and the connected RADIAS-R up for bids. I'll see once I get there.
Thanks again.
_________________
Cheers,
Jim (aka EJ2) Karma-Lab Associate Combi Developer

CATALYST v 2 Blast of Inspiration for KRONOS & OASYS: http://www.karma-lab.com/sounds/catalyst2.html
CATALYST v 1 Combi Explosion for KRONOS, OASYS, M3, & K-M50: http://www.karma-lab.com/sounds/catalyst1.html
CHEMISTRY 3, a Groove Injection for Your Karma: http://www.karma-lab.com/sounds/chem3.html
SoundCloud MP3 Demoshttps://soundcloud.com/ej2-sc