View previous topic :: View next topic |
Author |
Message |
Banditos
Joined: 21 Dec 2017 Posts: 4
|
Posted: Thu Dec 21, 2017 2:17 am Post subject: TR rack to remember my last used preset after restart |
|
|
Hi, I have my TR rack for just a couple of months now and couldn't figure this out. It is always turn on to the A00 trinity overture or something like that. Can I set something in the menu to remember my last used preset after turning off and on again?
Also can I somehow put a compressor as a master effect to the master out to reduce the dynamic range a bit?
Thanks! |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3796
|
Posted: Thu Dec 21, 2017 6:35 pm Post subject: |
|
|
In Global, System Preferences, select Power On mode to Memorise and then save the setting. |
|
Back to top |
|
|
Banditos
Joined: 21 Dec 2017 Posts: 4
|
Posted: Thu Dec 21, 2017 11:56 pm Post subject: |
|
|
Thanks for your answer unfortunately I cannot find this in the menu, are you sure this is in the trinity rack (TR-rack)? If so could you be more specific where should I find it? Thank you. Maybe I should make a system reset? I bought it second hand. |
|
Back to top |
|
|
Timo Platinum Member
Joined: 24 Jan 2002 Posts: 3109 Location: Kaoss central, England
|
Posted: Fri Dec 22, 2017 10:48 pm Post subject: |
|
|
If you're able to remember the last Program used, it would be a feature that is not available on the regular Trinity keyboard. I've looked at the manuals and there's no mention of such a feature on TR-Rack either. Furthermore, there are no so-called "System Preferences" in the Global section, so I'm guessing that voip may be refering to the Korg TR-61 keyboard (a Triton-based keyboard) not the Trinity TR-Rack.
And unfortunately no, you can't place any dynamics (compressor, limiter, etc.) on the master effects. The Master Effects are limited to modulation-based effects (Chorus, Phaser, Flanger) and Reverb/Delay effects only. _________________ [Free Moss Set For All Workstations With Moss Expansion]
[Infekted.org - Original Access Virus Forum & Community]
Trinity V3 PBS | Radias KB | Virus TI Snow | Virus Indigo 1 | 505 Groovebox |
|
Back to top |
|
|
Timo Platinum Member
Joined: 24 Jan 2002 Posts: 3109 Location: Kaoss central, England
|
Posted: Fri Dec 22, 2017 11:02 pm Post subject: |
|
|
You can however fake it, by setting all Programs in a Combi (or channels on the Sequencer) to share the same insert effects...
In which case you can go to Combi or Seq mode, set up a size-8 insert effects channel, followed by adding a size-2 or size-4 Compressor/Limiter on the last slot, and then point all the channels of the combi/seq to the same effects channel, and they will all be compressed together. Would leave you with two effects slots free before the dynamics kick in, and of course you can still have the standard Master Effects (chorus/phaser/reverb/delay) after all that, if required.
Using a size-4 compressor/limiter over a size-2 version also gives you the option of more elaborate multi-band dynamics rather than just single-band. _________________ [Free Moss Set For All Workstations With Moss Expansion]
[Infekted.org - Original Access Virus Forum & Community]
Trinity V3 PBS | Radias KB | Virus TI Snow | Virus Indigo 1 | 505 Groovebox |
|
Back to top |
|
|
Banditos
Joined: 21 Dec 2017 Posts: 4
|
Posted: Fri Dec 22, 2017 11:08 pm Post subject: |
|
|
Thank you your answers, and I guess there is no such thing as save as favorite or mark somehow a preset. |
|
Back to top |
|
|
Timo Platinum Member
Joined: 24 Jan 2002 Posts: 3109 Location: Kaoss central, England
|
|
Back to top |
|
|
Banditos
Joined: 21 Dec 2017 Posts: 4
|
Posted: Sat Dec 23, 2017 1:33 am Post subject: |
|
|
Thanks I'm gonna check it! |
|
Back to top |
|
|
|