|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
Stefano74
Joined: 17 Jul 2018 Posts: 3
|
Posted: Tue Jul 17, 2018 9:50 am Post subject: Edit instrument from midi file GM |
|
|
How can I change, for example, the Grandpiano (GM) to Grandpiano/string of the korg pa900 and then save with the changes made with Korg instruments. Please Help me. |
|
Back to top |
|
|
nitecrawler Platinum Member
Joined: 22 Mar 2007 Posts: 975 Location: from a mile high to the the AZ desert
|
Posted: Tue Jul 17, 2018 3:49 pm Post subject: |
|
|
Stefano
First of all, go to sequencer by touching the sequencer mode button. on the top end of the sequencer page touch the down arrow. From that screen touch load song. on song selection page find your midi file. It could be on your Disk, a SD card, or USB. Move to the proper location by hi lighting the page on lower left edge of page and getting your midi file. once you have it touch select. Your sequencer page will show tracks one through eight. (If you need to access a higher track, touch the dedicated track select button) once you have determined which track you want to change, just touch it on the screen. A sound select screen will pop up up. Find your preferred sound, touch it and then touch exit button. Once you have made all the changes you want, touch the right upper down arrow button on your screen and then touch save song. That will bring you back to the original midi file location. Touch the save button and you are done. NOTE, if you wish to save the file in a different location use the the lower left hand button to find your new location. Touch the location where you want the file, hit save and OK and you are good. Hope this helps.
Eric _________________ http://www.soundclick.com/bands/default.cfm?bandID=807494
Montage M7, Pa5x76, Nautilus, PA3Xle, Oasys 76, Mini-Moog, EMU Audity 2000, Motion Sound KBR 3D amp, Presonus and Reaper DAW W/Tannoy Reveal 501A powered monitors |
|
Back to top |
|
|
Stefano74
Joined: 17 Jul 2018 Posts: 3
|
Posted: Tue Jul 17, 2018 4:05 pm Post subject: |
|
|
Thank you so much Eric, you were very good at explaining the procedure. I followed the step by step instructions. Thank you.. thank you ! |
|
Back to top |
|
|
nitecrawler Platinum Member
Joined: 22 Mar 2007 Posts: 975 Location: from a mile high to the the AZ desert
|
Posted: Tue Jul 17, 2018 6:03 pm Post subject: |
|
|
You are welcome. And, welcome to the forum. _________________ http://www.soundclick.com/bands/default.cfm?bandID=807494
Montage M7, Pa5x76, Nautilus, PA3Xle, Oasys 76, Mini-Moog, EMU Audity 2000, Motion Sound KBR 3D amp, Presonus and Reaper DAW W/Tannoy Reveal 501A powered monitors |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|