|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
Jspitza
Joined: 30 May 2019 Posts: 2
|
Posted: Thu May 30, 2019 2:03 pm Post subject: New Volca bass not saving parameters |
|
|
Good Morning all!
New user here and new to Volca series. Although reading the news paper manual, I keep waking up to my bass powered down despite turning off auto power off mode and saving.
Also, bass freezes after first powering up and is not responsive despite ordering the correct power supply. I then need to remove the ac cable to either turn on or off the Volca. Once midi note data is sent from DAW and if I don’t even think about touching the bass, it runs flawlessly and I’m a happy camper. Thank you for any assistance you can give. |
|
Back to top |
|
|
TheDoctor Full Member
Joined: 28 Mar 2019 Posts: 162
|
Posted: Fri May 31, 2019 1:50 pm Post subject: Re: New Volca bass not saving parameters |
|
|
Jspitza wrote: | Good Morning all!
New user here and new to Volca series. Although reading the news paper manual, I keep waking up to my bass powered down despite turning off auto power off mode and saving.
Also, bass freezes after first powering up and is not responsive despite ordering the correct power supply. I then need to remove the ac cable to either turn on or off the Volca. Once midi note data is sent from DAW and if I don’t even think about touching the bass, it runs flawlessly and I’m a happy camper. Thank you for any assistance you can give. |
That's strange, what happened if you use battery? I personally have rechargeable battery to clean up a bit of cable. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|