View previous topic :: View next topic |
Author |
Message |
Andy L
Joined: 02 Mar 2010 Posts: 8
|
Posted: Tue Mar 02, 2010 9:50 am Post subject: SV-1 low output levels? |
|
|
Hi all, I'm having an issue with my SV-1 where the output levels seem to be quite low - I have both balanced XLR outputs going straight into my KRK Rokit 5 speakers and my playing is only really audible when the Master Volume is turned up to or near maximum.
I've also tried plugging the unbalanced jack outputs on the SV-1 into a small Behringer mixing desk, but even with everything turned up to maximum, the levels on the desk seem to be lower than you'd expect.
Have I missed something obvious, some kind of setting maybe? Is there any way this can be altered? Thanks in advance! |
|
Back to top |
|
|
craigalan Junior Member
Joined: 31 Jan 2010 Posts: 56
|
Posted: Tue Mar 02, 2010 3:06 pm Post subject: |
|
|
Have you tried digging into the settings on the software? I had to go in a tweak a few on mine to get all sounds to be equal volume. |
|
Back to top |
|
|
Andy L
Joined: 02 Mar 2010 Posts: 8
|
Posted: Thu Mar 04, 2010 9:30 am Post subject: |
|
|
No I hadn't tried that but I've found that all sounds - even the louder presets - seem to be quieter than you'd expect with the Master Volume turned up to maximum, and I was just wondering if there was a way to increase the output level somehow or even if there was a fault with my keyboard... |
|
Back to top |
|
|
jerrythek Platinum Member
Joined: 28 Jan 2002 Posts: 2931
|
Posted: Fri Mar 12, 2010 3:23 am Post subject: |
|
|
Do you have a pedal connected to the SV-1? Do you have MIDI connected to it?
Regards,
Jerry |
|
Back to top |
|
|
Andy L
Joined: 02 Mar 2010 Posts: 8
|
Posted: Mon Mar 15, 2010 7:09 pm Post subject: |
|
|
I have the supplied damper pedal and USB to my computer connected, but no MIDI... |
|
Back to top |
|
|
kanthos Platinum Member
Joined: 04 Dec 2008 Posts: 1003 Location: Newmarket, Ontario, Canada
|
Posted: Mon Mar 15, 2010 7:19 pm Post subject: |
|
|
What mixing desk is it? Does it expect a -10dbV or +4 dbU signal? _________________ Keyboard Rig: Korg Kronos, Moog Sub 37, Waldorf Blofeld Module, Neo Instruments Ventilator II, Moog MiniFooger Delay, Strymon BigSky, Roland KC-150, Mackie 802-VLZ4 Mixer |
|
Back to top |
|
|
Andy L
Joined: 02 Mar 2010 Posts: 8
|
Posted: Wed Mar 17, 2010 3:05 pm Post subject: |
|
|
The mixing desk is a Behringer Eurorack UB502 and I'm not sure what signal it expects - I had a look in the manual and couldn't find anything either! Ideally, I'd like to use it without a mixing desk if possible. |
|
Back to top |
|
|
Doc_T
Joined: 12 Nov 2018 Posts: 10
|
Posted: Thu May 09, 2019 3:43 pm Post subject: |
|
|
Did you solve this problem? Nine years later and I experience the same problem: Line-Out is good, XLR out has a very low output level. What is my problem? |
|
Back to top |
|
|
i_am_binky Junior Member
Joined: 18 Jun 2011 Posts: 88
|
Posted: Wed Jun 05, 2019 2:36 pm Post subject: |
|
|
take your SV-1 to a tech... i had the same problem with weak output (XLR went first, then the 1/4" started going intermittent... then i used the headphone jack for a year or so.
had to take bunch'o'gear in for tune-up, had the SV-1 taken care of first; tech replaced 4 capacitors that were causing my audio out problems. |
|
Back to top |
|
|
|