Korg Forums Forum Index Korg Forums
A forum for Korg product users and musicians around the world.
Moderated Independently.
Owned by Irish Acts Recording Studio & hosted by KORG USA
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

trigger mode: How to make each to send a different midi note

 
Post new topic   Reply to topic    Korg Forums Forum Index -> Korg Electribe
View previous topic :: View next topic  
Author Message
hcv2424



Joined: 23 Nov 2018
Posts: 4

PostPosted: Fri Nov 23, 2018 2:25 pm    Post subject: trigger mode: How to make each to send a different midi note Reply with quote

how can i do that in trigger mode ? all pads send C, but i need them to send different notes to trigger a drum machine vsti

keyboard mode is not helpful in this situation. i need to send notes in different midi channels.
Back to top
View user's profile Send private message
russellclarke
Junior Member


Joined: 07 Jun 2019
Posts: 59

PostPosted: Fri Jun 07, 2019 10:54 pm    Post subject: Reply with quote

You may have found an answer by now, but...
    In Global Settings, set Trigger Mode to Seq 1st.
    Record the required note on each part.
    Triggering pads will now play the first note recorded on each part.
    If you need the electribe parts to be silent, set part level to 0.

If you need to run the sequencer without the drum machine triggering sounds at the start of every loop, go into Step Edit and set the velocities to 0. If your drum machine channels are monophonic, this may cut off any currently playing sound.
Back to top
View user's profile Send private message
TheDoctor
Full Member


Joined: 28 Mar 2019
Posts: 162

PostPosted: Sat Jun 08, 2019 2:50 pm    Post subject: Reply with quote

russellclarke wrote:
You may have found an answer by now, but...
    In Global Settings, set Trigger Mode to Seq 1st.
    Record the required note on each part.
    Triggering pads will now play the first note recorded on each part.
    If you need the electribe parts to be silent, set part level to 0.

If you need to run the sequencer without the drum machine triggering sounds at the start of every loop, go into Step Edit and set the velocities to 0. If your drum machine channels are monophonic, this may cut off any currently playing sound.

Nice workaround, when somebody find solution instead of complain. Good job!
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Korg Forums Forum Index -> Korg Electribe All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group