|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
Travelinni Guest
Joined: 17 May 2019 Posts: 70
|
Posted: Tue May 21, 2019 4:28 pm Post subject: |
|
|
oh and btw if you get those cards , check the maximum capacity that the korg emx /esx will detect , i think it should be 64mb maximum or something like that . It's more than enough to store all your patterns , songs , everything in one card .
You can write several in the same card , just rename them all differently and you're all set , when your cards full , offload it to pc and you're sorted.
EMX-1 and ESX-1 SD : 32GB capacity.
EMX-1 and ESX-1 SM : 128mb SmartMedia Card |
|
Back to top |
|
|
russellclarke Junior Member
Joined: 07 Jun 2019 Posts: 59
|
Posted: Thu Jun 20, 2019 7:32 pm Post subject: |
|
|
Quote: | The problem is that I can't even reload .syx file made on ESX back to this same ESX (Banks A,B,C,D) ? Why is that? |
Check the MIDI filter settings on ESX, it may be blocking sysex. Alternatively, stay on the MIDI Dump page, I think this ignores MIDI filter settings. Also make sure the global channel is the same as it was when the sysex was dumped. You can check by viewing the syx file in a hex editor. It should be the least significant half of the third byte.
Quote: | I also want to upload MIDI data from ESX to EMX and use my old patterns there. |
This could be possible but it would take some hacking. The MIDI implementations for ESX and EMX are very similar. The only difference I can see is the device ID parameter, ESX=71 EMX=69.
http://www.korg-datastorage.jp/Software/MIDIImp/ESX.pdf
http://www.korg-datastorage.jp/Software/MIDIImp/EMX.pdf
The sysex data is a MIDI encoding of the pattern data. So you would need to convert sysex back to pattern, then convert ESX pattern to EMX pattern, then convert back to sysex (or just load as pattern data).
For converting between sysex and pattern you may be able use these scripts, with a little modification.
https://github.com/synthsofts/e2/blob/master/e2syx2pat.py
https://github.com/synthsofts/e2/blob/master/e2pat2syx.py
They were developed for e2, so you will need to modify pattern header, sysex header and file extensions to match the device you are using, but the main data conversion logic appears to be the same.
I don't know if there is a converter for ESX to EMX. You would need to map byte locations for parameters that are on both, I don't think they line up. Also set default values for parameters that are only on one device. _________________ https://freesound.org/people/bangcorrupt/
http://ccmixter.org/people/bangcorrupt
https://github.com/bangcorrupt |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|