|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
davhill
Joined: 23 Aug 2019 Posts: 10 Location: Kendal UK
|
Posted: Sun Sep 08, 2019 9:35 pm Post subject: Battery Fix - nearly, |
|
|
Hello again all,
I've nearly fixed my X5D but a problem has arisen.
I wanted to replace the backup battey and as it was the soldered-in kind, I got a coin cell holder with wires and fitted it to the mainboard.
I tried to desolder the battery pins but the solder didn't seem keen on melting. However, with a little encouragement - and a bit more heat - I could remove the battery. So far so good.
Despite using a good soldering gun and a sucker device, I couldn't get the factory solder out of the mounting holes. I was fearful of frying the board so I tinned the wires' ends and using a little cored solder, I attached the wires to the contact points on the top face of the board.
With the battery in and switched on, I reassembled my Korg, leaving the baseplate off.
When I fired it up, it went into test mode, which I hadn't asked for. On a restart, it showed the welcome message, followed by the 'battery low' message (0.46 volt). Measuring across my newly soldered points showed 3.2 volts.
I could then go into Global and reload everything. Everything is fine and the voices in Combi and Prog are all there so the only problem is the above error message.
It seems I've introduced some resistance into the circuit but I've no real electronics experience. i could send the mainboard away to a friend who has such exepreince but I'm puzzled about what happened. |
|
Back to top |
|
|
mrrstrat
Joined: 18 Nov 2019 Posts: 6 Location: Rockford, IL
|
Posted: Fri Nov 22, 2019 12:56 pm Post subject: |
|
|
Soldering gun - like you find at Menards or Home Depot - is a definite no-go. Try a 30 or 40 watt iron with a fine tip. Copper Solder braid works great to wick away melted solder and leave you a clean set of terminals to solder to.
Use a fine (0.032) 60/40 rosin core solder. _________________ -----------------------------------------------------
Noise Maker.
https://www.dimarzio.com/artists/michael-rogers |
|
Back to top |
|
|
davhill
Joined: 23 Aug 2019 Posts: 10 Location: Kendal UK
|
Posted: Sat Nov 23, 2019 12:30 am Post subject: |
|
|
Thank you, mrrstrat,
I the end, I took my mainboard to a friend of a friend with experience
of soldering of the kind required. He found that I'd damaged a track on the
board and was able to fix it by bridging the break with a length of very fine wire held in place with two tiny blobs of solder.
The outcome is that my X5D is now fixed and equipped with a battery holder that permits quick and easy changing of the coin cell. I'm happy now! |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|