View previous topic :: View next topic |
Author |
Message |
RWolthuis
Joined: 23 May 2020 Posts: 23 Location: Michigan
|
Posted: Sat May 30, 2020 4:01 pm Post subject: Auto Song Setup Newby Question |
|
|
I place Combi A12 into the sequencer and record just fine. I want to add a new track. I disable multi-record, assign a program to the next empty track, in this case track seven, make sure I’m recording that track. When I arm the sequencer I see “rec” as I’d expect on the track, but I play and get no sound.
I assume I’m missing something and I’d appreciate suggestions. |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3776
|
Posted: Sat May 30, 2020 6:09 pm Post subject: |
|
|
Check the MIDI channel assignment for the new track. The timbre will only respond to MIDI messages on that channel. For the timbre to respond to the keyboard, set it to MIDI channel 01.
. |
|
Back to top |
|
|
RWolthuis
Joined: 23 May 2020 Posts: 23 Location: Michigan
|
Posted: Sat May 30, 2020 11:40 pm Post subject: |
|
|
Thanks, but there are three timbres already assigned to channel 1. I figured it out, however. Went to track parameters and assigned a new channel to the new parameter. |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3776
|
Posted: Sun May 31, 2020 8:13 am Post subject: |
|
|
Which MIDI channel did you assign to make the new timbre sound?
All 16 timbres could be assigned to the same MIDI channel. The only problem with that is polyphony limits could be reached with just a couple of played notes, depending on the timbres used.
. |
|
Back to top |
|
|
RWolthuis
Joined: 23 May 2020 Posts: 23 Location: Michigan
|
Posted: Sun May 31, 2020 12:38 pm Post subject: |
|
|
Thanks for your help. I assigned the new timbre to an unused channel. What I don’t understand is when I tried to assign it to MIDI 1 and press record, the three timbres already assigned channel 1 in the combination light up with “record” and I couldn’t record the new one with that channel assignment. |
|
Back to top |
|
|
RWolthuis
Joined: 23 May 2020 Posts: 23 Location: Michigan
|
Posted: Sun May 31, 2020 12:39 pm Post subject: |
|
|
Thanks for your help. I assigned the new timbre to an unused channel. What I don’t understand is when I tried to assign it to MIDI 1 and press record, the three timbres already assigned channel 1 in the combination light up with “record” and I couldn’t record the new one with that channel assignment. |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3776
|
Posted: Sun May 31, 2020 7:31 pm Post subject: |
|
|
Is the status for the new timbre set to INT in the MIDI settings page?
. |
|
Back to top |
|
|
|