View previous topic :: View next topic |
Author |
Message |
horsegrip
Joined: 04 Jan 2010 Posts: 8
|
Posted: Wed Mar 17, 2021 11:17 am Post subject: MIDI thru question. |
|
|
Was working at one point, but not now
MIDI keyboard (Ch1)->MIDI Thru of Rack
MIDI In/Out eMagic 8x8 MIDI interface <Korg> On
Controller-> KORG
Sys Exc-> Ch1
Tested MIDI keyboard on other devices=ok
Tested Keyboard straight in Rack Midi In=ok
Am I missing something?
Another question, can I do a factory reset without losing and reloading all combi/banks/etc?
Regards |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3781
|
Posted: Wed Mar 17, 2021 2:48 pm Post subject: |
|
|
MIDI Thru is a simple buffered output of the MIDI data coming through the MIDI In port. There is no data path back to the MIDI In port from MIDI Thru. This means that connecting a MIDI keyboard to MIDI Thru will not be "seen" by the Triton Rack's tone generator.
. |
|
Back to top |
|
|
horsegrip
Joined: 04 Jan 2010 Posts: 8
|
Posted: Thu Mar 18, 2021 9:22 am Post subject: |
|
|
how would you setup it up? |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3781
|
Posted: Thu Mar 18, 2021 4:31 pm Post subject: |
|
|
It depends on what is needed from the setup.
Connecting the MIDI keyboard's MIDI Out to the Triton Rack's MIDI In will allow the MIDI keyboard to play the Triton Rack tone generator. If the MIDI keyboard's MIDI data also need to be passed to the PC, then connect the Triton Rack's MIDI Thru to one of the eMagic's MIDI Ins, and configure the eMagic and the software on the PC appropriately.
There will be other setups, but their configuration will depend on what the system is intended to do.
. |
|
Back to top |
|
|
|