Convert MP3 (or wave) to Pad

Nemik · Post by **Nemik** » Sat Nov 19, 2016 9:17 pm

you need to create new DK and import wave sample there assigning to keys your choice.
Then create new pad, track type DR and set Pad type for One Shot.
You need set Pad Sync.
Off --->No synchronization. The sequence will start as soon as you press the PAD button.
Continued -->Like a Fill, the pattern will start immediately, in sync with the Arranger’s or active Player’s Tempo. Depending on the current position of the beat counter, it might not start from its very beginning; instead, it will continue from the current position.
For example, if the Arranger’s or Player’s beat counter shows the third beat, and is playing tick 91, the Pad will start from its third beat, at tick 91.
Beat --> The sequence will start at the next beat, in sync with the Arranger’s or Player’s Tempo. It will start from its very beginning (that is, tick 1 or measure 1).
Then record one note (one you wanna effect) edit if nessary and save it.

mintjamman · Post by **mintjamman** » Sun Mar 19, 2017 11:39 pm

Thanks Nemick I think I now understand the principle that you are explaining, I cannot see any mention of this in the user manual but I have software to edit the file and will see what I can do

Thanks again

Nemik · Post by **Nemik** » Sun Mar 19, 2017 11:48 pm

Pa3x has limit is a maximum of 21.8 seconds is allowed for
each sample.
Same for mono and stereo sample.
for Pa4x:

Korg Pa4x User Manual on Page# 451 wrote:You can load samples (mono or stereo) in a 8 or 16-bit resolution, and a
sampling frequency rate from 11,025 to 48,000Hz. Loaded samples always
preserve their original resolution.
If the sample exceeds the maximum size allowed (1,048,576 samples, corresponding
to 1 Megasample, either mono or stereo), it will be truncated. A
warning will appear in the display.