|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
FenTigger
Joined: 29 Nov 2015 Posts: 3 Location: Below Sea Level
|
Posted: Sun Nov 29, 2015 7:29 pm Post subject: Module VCF Cutoff Patchpoints |
|
|
I got my MS20M a few months back, and this has sort of been bugging me, but I've confirmed it's an issue today.
I've set up my Analog 4 to dive the MS20 using CV, so CV and Gate are fine. I then tried using it to modulate the filter cutoff by patching into both the HP and LP filter cutoffs on the patchbay. I'm sending it a +/- 5v linear CV from the A4, but it makes absolutely no difference to the filter cutoff frequency. I'm I missing something obvious, or does it sound like I've got a duff unit?
Thanks for any pointers. |
|
Back to top |
|
|
Redmond Barry Full Member
Joined: 02 Oct 2011 Posts: 131
|
Posted: Wed Dec 02, 2015 11:15 pm Post subject: |
|
|
Might be defective, the most obvious thing would be that the EG2/EXT knobs are still turned down but I doubt you did that. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|