|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
synthpeter Junior Member
Joined: 25 Jun 2019 Posts: 96 Location: Netherlands
|
Posted: Mon Sep 16, 2019 10:38 am Post subject: Monologue 2.0 firmware breaks LFO/EG INT in sequencer |
|
|
Here's a warning for those who want to update the Monologue firmware to version 2.0. Introduction of Active Step has an unexpected side effect:
With the motion/slide/note switch set to motion, firmware 2.0 no longer allows setting a negative value for LFO/EG INT while pressing a sequencer button. Pressing a sequencer button and then SHIFT and wiggling LFO/EG INT does nothing (like it used to give a negative LFO/EG INT on FW 1.14). Instead it interprets the button press and SHIFT as a setting for active step. This means also that setting PITCH in 100 cents is blocked while pressing a sequencer button with the motion/slide/note switch set to motion.
So, make sure you weigh the pros and cons of 1.14 versus 2.0 before you upgrade. |
|
Back to top |
|
|
synthpeter Junior Member
Joined: 25 Jun 2019 Posts: 96 Location: Netherlands
|
Posted: Thu Sep 26, 2019 12:50 pm Post subject: |
|
|
Short update..
There is a work around to get negative values for LFO/EG INT while motion sequence recording.
Assign either LFO or EG INT to the slider, and motion record using the slider. This way you don't have to press SHIFT while in motion sequence recording mode.. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|