|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
aillo1
Joined: 08 May 2017 Posts: 1
|
Posted: Mon May 08, 2017 6:16 pm Post subject: E2S After update firmware does not boot |
|
|
Hi there.
My E2Sampler is frozen after i updated from 1.16 to 2.02
Now does not go ahead the logo screen.Seems the firmware installed may not be well.
Any idea how to make a total factory reset?
Which pads/buttons to hold down for it to boot into some fail safe where you can flash a new firmware?
And last, doing this process kills the warranty? (i cant undestand very well the license agreement in the page where i downloaded the firmware (my english as you can see is not so good)).
Thx a lot
Rafa. |
|
Back to top |
|
|
Cade Full Member
Joined: 20 May 2016 Posts: 127
|
Posted: Fri May 19, 2017 6:06 pm Post subject: Re: E2S After update firmware does not boot |
|
|
aillo1 wrote: | Hi there.
My E2Sampler is frozen after i updated from 1.16 to 2.02
Now does not go ahead the logo screen.Seems the firmware installed may not be well.
Any idea how to make a total factory reset?
Which pads/buttons to hold down for it to boot into some fail safe where you can flash a new firmware?
And last, doing this process kills the warranty? (i cant undestand very well the license agreement in the page where i downloaded the firmware (my english as you can see is not so good)).
Thx a lot
Rafa. |
Sounds like you're going to have a difficult time doing a factory reset, if the machine is frozen, and you can't see the screen.
To restore the Korg Electribe to factory defaults:
-Select the Factory Reset option from the DATA utility menu.
-Press Menu/Enter to begin the process. NEVER turn off the power during reformatting
If it is just a screen issue, and you can't see the LCD screen, you could try the following:
To Factory Reset:
- turn off your e2 and turn it on again and wait like 30 seconds until it's fully loaded
- press Menu/Enter button
- press < button 2 times
- press Menu/Enter button
- press < button 2 times
- press Menu/Enter button
(thanks to forum member: "Because789")
Hope this helps _________________ My Gear:
Korg Electribe 2 Sampler, Keith McMillen Instruments K-Mix, Korg Volca Bass, Cyclone Analogic TT-303, Novation Ultranova, Roland System-1, Roland JP-08 Boutique, Roland SH-201, Focusrite Saffire PRO 14, Korg Gadget v3 on iPad Air, Reason 10 on ZenBook Pro |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|