Korg Forums

[tombikadam]

how can I increase the volume of imported sample (wave loop) ???

[Asena]

Sound Edit, And Normalize! Than save it again,
_________________
www.globalsound.se

KORG PA 5-X/YAMAHA GENOS 2/YAMAHA A 5000
LIONSTRACK X 76 & GROOVE XR
MEDELI AKX-10




MacbookproM2-Ssd/Logic/Neuman/Kali Audio8/Komplette14SDD/ Apollo Twin/PIONEER XDJ RX 2
LOTS OF SAMPLE SOUNDS!
KorgPaManager V 5

[humair]

I also felt that imported samples specially loops did not have enough sound/punch. One solution that someone suggested to me was to edit the sound and use same sample on both oscillators. This make a big difference.
It worked for me.
_________________
--------------------------------------------
Pa4x - Current
Pa3x - Previously
Pa1x - Previously
Pa80 - Previously
i30 - Previously
O1W - Previously
========================

[AntonySharmman]

I guess all your similar references are about custom DK Sounds (and time sliced loops) !
DK Sound interface has been made actually to host stereo samples so If you use a monophonic sample even normalized
to 0db , it will be in the best case the 50% of the volume compared to any stereo factory DK element , that's why many
of you believe that there is a issue there !
So if you want your custom drum elements to be loud and punchy then pick up only stereo wav/Aiff samples you like ,
use a sound editor to normalize them properly and then import them in your Pa arranger.

Pa4X factory drum samples have been heavily processed with advanced sound editors , limiters and compressors ,
including ambience data and regardless of their sound taste for us , you can't 'beat' them with amateuristic drum samples
that you have gathered from internet sources.

Hope this helps
_________________
Music Conductor - Sound Engineer & Developer - Automotive SMPS/RF R&D - Electronics Engineer
PaSeries Demos - WavesArt.eu - KorgPa.gr <> Facebook

Keyboards : Steinway-D, Kronos X, Pa5X 76, Pa4X 76, Montage M7 , Roland-XV88, Emu3,Emax II,Synclavier II,Yamaha DX Series, ΟΒ-8V