|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
4GodnWV Full Member
Joined: 28 Jan 2017 Posts: 129 Location: Teays Valley, WV
|
Posted: Wed Nov 08, 2017 1:02 am Post subject: Assigning SW1 or 2 to play/mute a timbre in a combi |
|
|
I know I can use Karma to switch between groups of timbres in a combi by setting modules a-d to Karma scenes and switches 1-8, but want to do is assign SW1 or 2 (the ones just above the joystick) to turn a single timbre in a combi on or off.
I normally just use a fader, (or exp pedal) but in this case a preset volume is needed.
I have looked everywhere I can think of, but can’t seem to figure out how to do it.
Ideas? |
|
Back to top |
|
|
psionic311 Platinum Member
Joined: 14 Nov 2014 Posts: 1046 Location: Orlando, Florida USA
|
Posted: Wed Nov 08, 2017 6:18 am Post subject: |
|
|
One way to approach this is by using the Dyn Comp FX.
For example, assign the Dyn Comp to the sound or group of sounds you want to mute/unmute. Set the FX gain to something like 15. Then set the AMS source for the gain to SW1, and its amount to -15. Pressing SW1 will then decrease the FX output to 15 - 15 = 0, which will effectively mute the sound(s).
Reverse the amounts if you want the timbre to be muted at first, then turn on to a preset level after you press SW1. In other words, set FX gain to 0, and SW1 amount to 15 to turn on the timbre with a volume of 15.
HTH |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|