View previous topic :: View next topic |
Author |
Message |
trifty
Joined: 30 Apr 2018 Posts: 3
|
Posted: Mon Apr 30, 2018 4:39 pm Post subject: NanoKontrol 2, No LED in Mackie Mode |
|
|
So I just picked up the nanokontrol 2 today and am struggling to get the LEDs to work with Studio One!
Instructions on Studio One says to plug in the kontrol while holding SET and REW which works well for all the buttons. But it totally disables ALL the LEDs on the controller except for the power led.
Any ideas guyys ? |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3773
|
Posted: Mon Apr 30, 2018 6:31 pm Post subject: |
|
|
The Korg MIDI drivers need to have been installed before the nanoKontrol was plugged in for the first time.
. |
|
Back to top |
|
|
trifty
Joined: 30 Apr 2018 Posts: 3
|
Posted: Tue May 01, 2018 4:38 am Post subject: |
|
|
voip wrote: | The Korg MIDI drivers need to have been installed before the nanoKontrol was plugged in for the first time.
. |
Thanks for the reply! Hmm but I did install the drivers on Windows but it didn’t make a difference to the LEDs 🤔 |
|
Back to top |
|
|
trifty
Joined: 30 Apr 2018 Posts: 3
|
Posted: Tue May 01, 2018 4:44 am Post subject: |
|
|
Oh Finally figured it out! I didn't set the SEND to the Korg but only the RECEIVE from. Works now! |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3773
|
Posted: Tue May 01, 2018 1:02 pm Post subject: |
|
|
trifty wrote: | Oh Finally figured it out! I didn't set the SEND to the Korg but only the RECEIVE from. Works now! :D |
Excellent. Pleased to hear it.
. |
|
Back to top |
|
|
|