|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
KaffeSloth
Joined: 24 Nov 2018 Posts: 2
|
Posted: Sat Nov 24, 2018 7:18 pm Post subject: Korg 01/W FD capasitor question |
|
|
Hi, I recently bought a Korg 01/W FD and knowing that the caps tends to leak I checked them out. And sure enough some of them are leaking. I'm planning on replacing all the caps since it’s only a matter of time before the other ones start to leak as well.
I've already bought some caps, but I thought to double check with you guys if they are suitable for my purpose.
For the main board, I bought the UKZ series caps from Nichicon. (a side note is that the supplier I bought from didn't have any 25v caps at 10uF, so I bought 10x caps that’s rated for a 100v, will this cause any problems?)
For the sound output (where there are 8x bi polar caps) I bought the USE bi-polar series caps from Nichicon
For the PSU I haven't bought anything yet, but I'm planning to buy the caps from Nichicon's UPW series.
Regards, a total amateur |
|
Back to top |
|
|
T3owner Senior Member
Joined: 17 Jun 2011 Posts: 368 Location: USA
|
Posted: Sat Nov 24, 2018 10:07 pm Post subject: Re: Korg 01/W FD capasitor question |
|
|
KaffeSloth wrote: | Hi, I recently bought a Korg 01/W FD and knowing that the caps tends to leak I checked them out. And sure enough some of them are leaking. |
OK, it's good you found them before the electrolyte causes corrosion damage.
KaffeSloth wrote: | I'm planning on replacing all the caps since it’s only a matter of time before the other ones start to leak as well. |
Not necessarily, but if you enjoy changing caps...
KaffeSloth wrote: | I've already bought some caps, but I thought to double check with you guys if they are suitable for my purpose.
For the main board, I bought the UKZ series caps from Nichicon. (a side note is that the supplier I bought from didn't have any 25v caps at 10uF, so I bought 10x caps that’s rated for a 100v, will this cause any problems?) |
In general Nichicon caps are decent, as are Panasonic/Matsushita. The higher voltage rating doesn't typically present a problem, as long as their physical size isn't an issue.
The UKZ caps should be fine for audio applications. Since they have low ESR, they should be good for supply decoupling as well.
KaffeSloth wrote: | For the sound output (where there are 8x bi polar caps) I bought the USE bi-polar series caps from Nichicon |
I presume you meant "UES" series.
KaffeSloth wrote: | For the PSU I haven't bought anything yet, but I'm planning to buy the caps from Nichicon's UPW series. |
Those should be up to the job.
KaffeSloth wrote: | Regards, a total amateur |
You seem to be doing OK, regardless of your experience. _________________ Korg: T3EX, 05R/W | Yamaha: Motif XF6 and XS6, A3000V2, A4000, YS200 | Fender Chroma Polaris | Roland U-220 | Etc. |
|
Back to top |
|
|
KaffeSloth
Joined: 24 Nov 2018 Posts: 2
|
Posted: Sun Nov 25, 2018 1:49 am Post subject: Re: Korg 01/W FD capasitor question |
|
|
Yes, I ment UES Thanks for the help |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|