View previous topic :: View next topic |
Author |
Message |
Ft13
Joined: 16 Jan 2012 Posts: 10 Location: Seattle
|
Posted: Mon Mar 04, 2019 2:08 am Post subject: Electribe 2 and Microbrute question |
|
|
I just picked up a microbrute and as cool as it is, the keyboard on it feels too plastic.
I’d love to just midi sync it to my Electribe 2, which I’ve done by the midi out on the Electribe to the midi in on the Microbrute, but I can “play” it on the Electribe.
I made sure the Electribe is set to internal for midi.
I essentially wanna program steps to arpeggiate the Microbrute as it will be mainly used for bass lines.
I’d love a bit of help getting this sorted out!
-Sin |
|
Back to top |
|
|
slug Senior Member
Joined: 03 Aug 2007 Posts: 371
|
Posted: Tue Mar 05, 2019 8:54 pm Post subject: |
|
|
Electribe outputs all 16 pads as the relevant MIDI channel. So if you have a sequence on pad 1, just ensure the microbrute is also set to channel 1 and it will play the same sequence. |
|
Back to top |
|
|
Ft13
Joined: 16 Jan 2012 Posts: 10 Location: Seattle
|
Posted: Wed Mar 06, 2019 4:31 am Post subject: |
|
|
You can’t change midi channels on the Microbrute. It is as is.
But I did find that it’s on channel 3.
Now my only issue is that the sequencer in it won’t sync to the BPM of the Electribe.
If only arturia’s forum would allow me access, but it’s broke af.
-Sin |
|
Back to top |
|
|
1_inch_punch Senior Member
Joined: 03 Sep 2012 Posts: 314
|
Posted: Thu Mar 07, 2019 12:10 am Post subject: |
|
|
You need the arturia connection software to change the MidiBrute channel - I had mine being sequenced by a single part/pad of the E2 no problem.
I then changed my mind and decided I wanted to use the MBrute's internal sequencer midi synced. It's currently running from a Circuit no problem.
Dload/Check the Arturia Connection software. I think that's what its called - or used to be. |
|
Back to top |
|
|
slug Senior Member
Joined: 03 Aug 2007 Posts: 371
|
Posted: Thu Mar 07, 2019 1:26 am Post subject: |
|
|
Ft13 wrote: | You can’t change midi channels on the Microbrute. It is as is. |
Wrong. You need the Microbrute Editor application to do this.
Ft13 wrote: |
Now my only issue is that the sequencer in it won’t sync to the BPM of the Electribe. |
Again, this behaviour is set in the Microbrute Editor application.
Ft13 wrote: |
If only arturia’s forum would allow me access, but it’s broke af. |
All you need to do is RTFM! |
|
Back to top |
|
|
Ft13
Joined: 16 Jan 2012 Posts: 10 Location: Seattle
|
Posted: Thu Mar 07, 2019 7:19 am Post subject: |
|
|
It took me a hot minute, but I finally found the midi manager software. Now everything is fine.
Now off to fix a staticy volume pot/knob on my podxt!
-Sin |
|
Back to top |
|
|
|