Is it possible to turn off midi out notes on emx1 or e2

Discussion relating to the Korg Electribe products.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
SirKeyz
Posts: 1
Joined: Mon Aug 03, 2020 12:08 am

Is it possible to turn off midi out notes on emx1 or e2

Post by SirKeyz »

I'm trying to clock sync my emx1 with my e2. I've done it both ways with each being the master but both units send midi to the respected channels on the other unit. The only work around I've found is using my mpc2000xl as a master to sync them because it has 2 separate midi outs, A and B. Is there a midi feature im missing on the Kong units that will only send clocks? Or is a third device necessary to achieve synchronization with out note information being passed?
DRX
Posts: 3
Joined: Fri Aug 17, 2018 1:04 pm

Re: Is it possible to turn off midi out notes on emx1 or e2

Post by DRX »

SirKeyz wrote:I'm trying to clock sync my emx1 with my e2. I've done it both ways with each being the master but both units send midi to the respected channels on the other unit. The only work around I've found is using my mpc2000xl as a master to sync them because it has 2 separate midi outs, A and B. Is there a midi feature im missing on the Kong units that will only send clocks? Or is a third device necessary to achieve synchronization with out note information being passed?
If i understand correct, try to setup in emx`s midi filter this combination OXXX. I`ll also check it on my gears later
Post Reply

Return to “Korg Electribe”