Korg Forums

[mazcote]

bonjour
je souhaiterai brancher wavestate que j ai et bar (roland tr8s) que je compte acheter comment fait on ?
cordialement
MAZCOTE

[voip]

So the question translates to:

Hello
I would like to connect wavestate that I have and bar (roland tr8s) that I intend to buy how do we?
Kind regards
MAZCOTE

The answer is it depends on what you want to do with the two instruments.

The simplest connection would involve sending the audio Output L & R from the Wavestate and the MIX L & R from the TR-8S to an audio mixer, using 1/4" audio cables, and sending the Mixer Audio Outs through a PA system, a recorder (analogue or digital), or into a VST recording setup, and/or using the mixer's headphone output. If the mixer has individual channels, rather than stereo pairs, then connect the Wavestate's Output L & R to channels 1 & 2 on the mixer, and MIX L & R from the TR-8S to mixer channels 3 & 4. Set the mixer's Pan controls hard left for channels 1 and 3, and hard right for channels 2 and 4 to get a proper stereo image.

As a suggestion, the best thing to do would be to get a set of at least six 1/4" jack TS audio cables (although twelve cables might be better), two standard MIDI DIN cables, and a couple of USB cables. This should allow most of the possible configurations to be set up without having to wait for additional cables to arrive. When sourcing the cables, consider the likely lengths of cables that might be required, based on the planned setup.

.