View previous topic :: View next topic |
Author |
Message |
Riklink
Joined: 28 Mar 2013 Posts: 14
|
Posted: Thu Feb 19, 2015 10:03 am Post subject: KP3 not looping |
|
|
Hi all,
Not sure if my KP3 is not working correctly. Brought second hand from ebay.
So after recording a sample the unit only plays back while i'm holding down the assigned sample button.
I was expecting it to run on a continuous loop.
Is this not the case?
Thanks for your replies |
|
Back to top |
|
|
rammstein Full Member
Joined: 06 Apr 2014 Posts: 103
|
Posted: Fri Feb 20, 2015 5:49 am Post subject: |
|
|
you need to complete the loop when sampling. when you stop the sampling before the loop ends, it becomes a one-shot. |
|
Back to top |
|
|
Spheric El Platinum Member
Joined: 21 Jul 2014 Posts: 795 Location: Liverpool
|
Posted: Fri Feb 20, 2015 3:19 pm Post subject: |
|
|
Hi Riklink,
On version 2 there is up to 4 different playback modes.
If your sample is green-it's a loop and has 4,while a oneshot is red and has but 2.
-Go into edit sample mode by holding shift and tapping your sample . You may then have to press your program encoder ,before selection with same encoder.Different modes for loop are re-sync start point or not, and toggle on/off variations . One shots can't change start point. |
|
Back to top |
|
|
Riklink
Joined: 28 Mar 2013 Posts: 14
|
Posted: Sat Feb 21, 2015 1:36 am Post subject: |
|
|
Great thanks guys
I'll give that a go |
|
Back to top |
|
|
|