|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
Aciphecs Platinum Member
Joined: 16 Aug 2010 Posts: 558 Location: Biblical Proportion, Michigan
|
|
Back to top |
|
|
Mazash
Joined: 20 Jul 2011 Posts: 4
|
Posted: Fri Jul 22, 2011 3:13 pm Post subject: |
|
|
Hi !
One question : if I plug the two stereo outs of the emx equipped with new tubes, to the ins of a kaosspad (3 for exemple) will it "kill" the quality of the tubes even if no effect is applied ? |
|
Back to top |
|
|
0same
Joined: 15 Sep 2011 Posts: 8
|
Posted: Thu Sep 15, 2011 12:57 pm Post subject: NOOB |
|
|
hi, i new to all this, just wanted to say thanks for the grate info.
so if i were to get a pair of "Genalex Gold Lion 'KT series' Tubes"
would they work?
thanks...
o and i found this, my be useful
EMX-1/ESX-1 Tube Calibration
1.Connect the stereo plug of the cable (see fig.) to PHONES and the monaural plug to
INPUT.
2. While pressing ERACE and STEP EDIT, turn the power on. “Valv Wup” is
indicated as stand-by for pre-heating, and also the waiting time is indicated.
Set up the volume knob and switches as follows:
MASTER VOLUME : MAX
TUBE GAIN : MIN
AUDIO IN LEVEL : MAX
MIC/LINE : MIC
3. “Ajst (L)” and a 4 digits figure are indicated in the LCD. If the value is leas than
0010, the test is O.K.. Press the 16 knob at the right bottom. If the value is over it, it is
required to adjust the valve. Adjust the variable resistors which correspond to the
channels referring to the photo below.
4. As well as “Ajst(L)”, “Ajst (R)” and a 4 digits figure are indicated in the LCD.
If the value is leas than 0010, the test is O.K.. Press the 16 knob at the right bottom. If
the value is over it, it is required to adjust the valve. Adjust the variable resistors
which correspond to the channels referring to the photo above.
5. Once the balance of L/R is automatically adjusted, “ValvGMax GainMx” is
indicated in the LCD. Turn the TUBE GAIN knob to MAX, and press the 16 knob.
6. Check the L/R balance of TUBE GAIN MAX, and return to the normal mode.[/img] |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|