|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
atonalsoul1
Joined: 01 Apr 2008 Posts: 1
|
Posted: Tue Apr 01, 2008 2:14 pm Post subject: Broken Switch and Knob-or How to disassemble the back panel? |
|
|
I recently got a used Korg Triton Studio and it seems it's seen some wear and tear. I found out to my surprise that it has a vocoder included on it. So I plugged in a 1/4 inch jack mic into the input and got the keyboard setup (correctly, yes) to use the vocoder. The problem is, on the back of the keyboard, the input volume knob has been depressed down into the back of the keyboard (and i believe unresponsive to changes anyway) and the mic/line switch is broken off. gahh.... if I could get them switched to where i need them, at least i could leave them there, but the back panel is being a pain. If I take out all the screws on the back except those holding on to sections of the input section (power plug in, midi control, pedal input...etc) it won't budge. How can I get into the back safely without dropping any pieces into the abyss of the keyboard?
~s |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|