|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
alvaroafduarte
Joined: 24 Dec 2009 Posts: 11
|
Posted: Thu Dec 24, 2009 3:25 pm Post subject: Program editing inside COMBI mode |
|
|
I just got my M3, and already stuck.
I have Juno-G as well, and in the Juno I can adjust the cutoff, ressonance, attack, release of each layer separately inside the roland's combination mode.
In the M3 I could only adjust these parameters with the Real Time controler, and when I adjusted one layer, the other ones were adjusted at the same time. Bottom line, I had to go back to the program mode, adjust the programs and then load them in the COMBI mode.
I was wandering if there is any way to do this like the Juno G, each layer separately inside the COMBI mode.
Thanks! |
|
Back to top |
|
|
alogie Junior Member
Joined: 30 Aug 2007 Posts: 53
|
Posted: Thu Dec 24, 2009 5:22 pm Post subject: |
|
|
Look at the Timbre Adjust settings. You can set these for each part and they get saved with the Combi. |
|
Back to top |
|
|
alvaroafduarte
Joined: 24 Dec 2009 Posts: 11
|
Posted: Thu Dec 24, 2009 6:20 pm Post subject: |
|
|
Thank you, but I just figured it out...
It's easier than I thought.
It's on Tone Adjust on Control Surface. All I had to do is select the timbre I wanted.
It's my second day with this amazing workstation, and it had already blown my mind.
Nevertheless, thank you. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|