|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
retired&wired
Joined: 18 Jul 2011 Posts: 41
|
Posted: Thu Aug 25, 2011 4:35 am Post subject: EXP-2 pedal defaults to JS+Y at boot time |
|
|
I have set up my EXP-2 pedal to emulate the JS+Y modulation in Global mode for my Kronos. When I boot up the Kronos and play a program, the pedal is in the back (off) position and the JS+Y modulation is active. I have to press the pedal down and back off to stop the modulation. From then on, the pedal works as expected: (pedal off - no modulation, pedal on - modulation).
I have connected the pedal's cable to the output 2 jack on the pedal based on the picture on the box. There was no manual included!
Is there a way to have the pedal default to 'off' at boot time?
Thanks. |
|
Back to top |
|
|
Ksynth Platinum Member
Joined: 01 Jun 2009 Posts: 1225 Location: Northern California, USA
|
Posted: Thu Aug 25, 2011 1:53 pm Post subject: |
|
|
You did save your Global settings right? Just checking. |
|
Back to top |
|
|
retired&wired
Joined: 18 Jul 2011 Posts: 41
|
Posted: Thu Aug 25, 2011 5:15 pm Post subject: |
|
|
Ksynth wrote: | You did save your Global settings right? Just checking. |
Sure did. I just rebooted to make sure, went to Global P2:Controllers/Scales, then the Controllers tab.
Foot Pedal Assign is set to JS+Y (CC#01). |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|