Korg Forums

[.Jens]

Hi everybody,

I encountered a strange behaviour of my Kronos lately, and I would appreciate if anyone could crosscheck this at their machines.

When I send out a signal through one of the outputs and feed it back in via input 1/2 (e.g. to use the Ventilator as external leslie effect for organs), I can set the send level to MFX1 or 2 (e.g. reverb) for each of the audio inputs.

However, when changing the program and reloading the patch (no matter if it's a combi or program) the reverb does not sound - despite the send level seems to be stored correctly. If I change the reverb level slightly (in the audio tab or via the control section), it comes back into play.

At the moment, I also can quite surely exclude that this is an interference with differing settings from the control surface - I can store different values or the same there for send, in each and every case after a patch change the send level will effectively be set to zero (even if the stored values are still correct).

Can anyone confirm this? OS version is 2.0.6.

[SanderXpander]

I can't check atm but I used to run my Ventilator back into my Kronos for a touch of reverb, never ran into any problems. But I may have used an IFX slot instead...