View previous topic :: View next topic |
Author |
Message |
ChiefDan
Joined: 08 May 2015 Posts: 6
|
Posted: Thu May 14, 2015 5:13 am Post subject: Mixer/controller template moved to a combi... |
|
|
If I have an organ program that has a mixer / controller set-up with drawbars assigned to faders, perc. On/off to a button, etc. How do I get that into a combi and have that controller template happening when I call that up?
I have a simple combi with a piano assigned to a controller and an organ assigned to the Kronos, but alas, no organ controls to play with. |
|
Back to top |
|
|
SanderXpander Platinum Member
Joined: 29 Jul 2011 Posts: 7860
|
Posted: Thu May 14, 2015 7:42 am Post subject: |
|
|
You need to set the control surface to Tone Adjust and, on the combi's control surface page, specify the active timbre on the right hand side. My guess is your organ is on timbre two and your Tone Adjust is affecting your piano sound on timbre one. Don't forget to save afterwards. |
|
Back to top |
|
|
ronnfigg Platinum Member
Joined: 26 Mar 2011 Posts: 2141 Location: CA
|
Posted: Thu May 14, 2015 10:05 am Post subject: |
|
|
Great tip Sander. I been meaning to do this also, but have been too busy to research it. Seems pretty intuitive. _________________ "To me the synthesizer was always a source of new sounds that musicians could use to expand the range of possibilities for making music."
Bob Moog |
|
Back to top |
|
|
ChiefDan
Joined: 08 May 2015 Posts: 6
|
Posted: Fri May 15, 2015 12:56 am Post subject: |
|
|
Finally was able to get at my Kronos. Your advice was perfect. Thank you veddy much! |
|
Back to top |
|
|
|