View previous topic :: View next topic |
Author |
Message |
optiprime
Joined: 05 Sep 2015 Posts: 3
|
Posted: Sun Sep 06, 2015 8:07 am Post subject: MS20M Kit Help |
|
|
Hi, I've just finished assembling my ms20m but I think I have some problems with the LFO. I thought the LFO was prepatched to the VCOs and filters but the MG/t.ext knobs have no effect. If I patch the square wave from the LFO into Total it works, but not if I patch the triangle wave? I've never played an ms20 before so maybe I am making some obvious mistake? Can anyone tell me if there is a problem with my ms20 because apart from this issue everything else seems to work fine and I really love this synth! Thanks |
|
Back to top |
|
|
Steinberger Full Member
Joined: 17 Jan 2012 Posts: 228
|
Posted: Thu Sep 10, 2015 3:18 am Post subject: |
|
|
Don't patch anything.
FM Off.
Set both filters cutoff to 5 (give it some elbow room to modulate)
Crank up the MG/T.Ext (how much it's allowed to effect the target)
Mess with MG frequency knob (hear your changes)
FM switch:
Check the documentation about how the FM switch ON changes the behavior of Frequency Modulation sections (only) MG/T.Ext knob. With FM switch on it adjusts how VCO 1 modulates VCO 2 (unique to the M).
Tutorials:
Then go watch all these videos https://m.youtube.com/playlist?list=PL3D3721AB90972CB5 99% of them apply to the M.
Welcome. _________________ SC: https://soundcloud.com/kdub101010
FB: https://www.facebook.com/KDubInYerFace |
|
Back to top |
|
|
optiprime
Joined: 05 Sep 2015 Posts: 3
|
Posted: Fri Sep 11, 2015 6:42 am Post subject: |
|
|
Steinberger wrote: | Don't patch anything.
FM Off.
Set both filters cutoff to 5 (give it some elbow room to modulate)
Crank up the MG/T.Ext (how much it's allowed to effect the target)
Mess with MG frequency knob (hear your changes) |
This is what makes me think my unit has a problem as when I do this there is no modulation of the sound.
Steinberger wrote: | FM switch:
Check the documentation about how the FM switch ON changes the behavior of Frequency Modulation sections (only) MG/T.Ext knob. With FM switch on it adjusts how VCO 1 modulates VCO 2 (unique to the M). |
With the FM switch on everything works as expected.
Thanks for the link, I watched these (and many other) videos before deciding to buy the kit. I will take the synth apart again at the weekend but I don't think these problems could come from something simple like an unplugged cable. |
|
Back to top |
|
|
Steinberger Full Member
Joined: 17 Jan 2012 Posts: 228
|
|
Back to top |
|
|
optiprime
Joined: 05 Sep 2015 Posts: 3
|
Posted: Sun Sep 13, 2015 7:10 am Post subject: |
|
|
You were right, when I took the synth apart I found one of the harnesses not properly attached. Now everything is fixed Thanks for your help |
|
Back to top |
|
|
|