Korg Forums

other switch toggle between mkI and mkII filters, very simple and effective

was planning to get VCO1 triangle output jack but I don't know where to put it on the panel...

here is a pic:

q3, it forces vco2 to sync

Mr. White, Looking at Remork's osc sync mod, I noticed the following: "a wise man on a nice forum mentioned that it would be best to use shielded wires and connect the shields to ground to avoid the oscillators locking when their frequencies are close. you run the risk of them syncing through stray ...

Also, having some MS-20M kit, envy, I am wondering if there is a way to add FM to the MS-20 kit? Thank you, Sjon I think that getting out vco1 triangle and a cv mixer (to mix incoming keyboard cv with vco1 triangle to vco2 cv input) we could do the trick :) don't know if we could expect something ...

as no one takes the bill, I did :) followed my clue tu look the schematics of the vintage korg and not the KIT board. trick is between Q3 and Q17 ;) http://s27.postimg.org/atmf2iq4f/11103034_10205788630509449_8624702767338897969_n.jpg http://s27.postimg.org/vchb7l41r/11391504_10205788941917234 ...

there is something that still make me think.. diode. in auxren mod, looking at where he soldered wires on diodes, he picked at the same polarity, as shown in the remork's vintage schematic. with it in mind it seems that everything is reversed from what I fugured, so instead of Q2 and Q4 we shoud use ...

successfully installed pwm, had a look at the sync mod from auxren and remork, one installed on the mini, other on vintage. I think we have to figure the pcb because the kit reissue is completely similar with the vintage :) I added a pic of the VCOs of my Kit, you could see the transistor cluster ...

any news about mods and patch points?

I'm attempting wiring of vco1 waveform outs, pwm and sync.