Korg Forums

also consider your interface. If it's a USB powered interface I'd bet your left nut that is the issue. I am dealing with it too.

M5 key won't let me program it. It works, but I can't select it during sequencing. Thoughts?

* only when using VCO2

ahhh it has something to do with VCO Group. All the 3 VCO on in the 3rd VCO Group. The one under M3

Super strange. I think you were right. At least in part. I was messing with the LFO and using FUNC and hit the two steps at the same time, I think, and they dropped back to being controlled by pitch knob. Not sure if it was just that issue. Or a combination but your input got me there.

Thanks!!

Hello,

Thanks for your response.

I am running midi. All 16 steps. So, M4 and M6 with VCO3, no matter when I put the pitch knob. How would I change the octave for just these two? Not sure how I got myself in to this. haha

how do I adjust pitch on certain hits. Other than the knob. So, I'll push a couple hits in and sometimes them shits come in extremely high. Or low sometimes. I can't figure out how or why.

Anyone experience this?

don't send it back. do a reset and play one of the pre programmed sequences. It will play. I did the same thing. Apparently I dicked around with something and turned it off. reset and works. hope this helps