Korg Forums

Hi, just tried this fix but no luck. When I try and change the tempo under 100bpm the counter moves in 2's so 99,97,95...... and so on, making some bpm's unobtainable, the tempo does not bounce around once set. Does the capacitor need to be of a certain type like silver mica? I just used a standard ...

Hi I have managed to sort it with a bit of searching around the forum. I found a post by Demitri I think apologies if the spelling is wrong.

I had to reinstall the R3 driver because I had changed the USB slot I was plugged into, then after a bit of swapping in's and out's I got it woking

Thanks

L

Hi thanks for your help.
I taped up power supply pin 1 on the USB plug and problem solved.

Thanks

Does anyone know how to get the R3 synth software to work at the same time as midi control in acid pro. If I open acid up first I can get acid midi to control the synth but the R3 software midi fails so I can't manipulate the sounds, but if I open the R3 software up first that works ok but acid midi ...

Hi, I have sorted the noise problem by disconnecting the power on the USB plug(I put tape over pin 1) no more noise. Now I have a problem with the midi, maybe this should be in another post, please advise if that is so. The problem is when I try to active midi in my software. The software is Acid ...

Does anyone know how to fix this problem, I have a korg R3 synth and a Mackie Onyx Blackjack usb interface. The problem is that when I have the USB for the R3 connected to run the midi and the R3 outs connected to the blackjack in's, there is bad noise, this stops when I unplug the R3's USB. I ...

Does anyone know how to fix this problem, I have a korg R3 synth and a Mackie Onyx Blackjack usb interface. The problem is that when I have the USB for the R3 connected to run the midi and the R3 outs connected to the blackjack in's, there is bad noise, this stops when I unplug the R3's USB. I ...

It may well be that it is some of the filters or mods don't update until they are re triggered because of the internal routing structure. My main gripe is when running a midi arrangement(piano roll) from a daw, with the arp where the midi is acting as if keys are being pressed, I can't get the arp ...

Thanks for replying You would think that synths would have improved enough over the years and these limitations would have been overcome, these digital synths are no more than software with a front end controller attached, the build quality is very poor and it looks like it cost 50p to make, I just ...

Hi could anyone tell me if I need to change a setting on the R3 to enable it to update the synth sound in real time while using the arpeggiator? If I change the sound of the synth while the arp is running the sound does not change, it is only when I stop and restart the arp in latch mode or ...