Korg Forums

can anybody tell me how much polyphony the drumkits use on the radias?

got it! now i understand.
thank you.

thank you for your reply michelkeijzers,i understand i have to multply it with the number of notes being played.
i do not understand INCLUDING the end of the not (until the release/effects have been finished).
can you explain?

if i am using a double program and i have a mono multisample on each oscillator how many voices are used?
if i am using a double program and i have a mono multisample on one oscillator and a stereo multisample on the other oscillator how many voices are used?

anybody have any more comments ?

anybody have anything to add to this discussion?

that made me laugh

thank you x-trade,that bit about individual routing is a new one to me.
are there any more areas/parameters of polyphony use i should know about?.
anybody else have anything to add?

below is a list of parameters that reduce polyphony on the radias, (according to the user manual!), page 80 unison function page 84 osc mod page 85 wave page 86 routing page 88 filttype page 88 drive/ws page 88 ws type if i am using one timbre with the unison function turned off and both the drive ...

AAAAAAAgh what is going on? how can the manuals be so wrong,even korg has difficulty finding its own polyphony loss!
now you tell me the comb filter uses extra polyphony? could it be possible that you filtered out a note? cutoff a note perhaps?

for anyone that is intererested,korg replied to me saying, A single timbre with unison switched off provides the maximum of 8 voices. also korg have had difficulty finding any combination of 'wave' and 'osc1 mod' that affects polyphony.(although it does say on page 27 of user manual that there is a ...

thanks again, i'm trying to get korg to give me the facts but they do not
seem very quick to answer.

thanks for trying to help,the vpm solution sounds good,not sure about the waveshaper.I also have a radias and in the manual it says that the waveshaper uses extra polyphony,so i hope you are wrong about the r3 because it does not mention this loss in the r3 manual. i have tried testing with fingers ...

i do not have a damper pedal . also the question i asked does not relate to the osc1 mod unison but to the fact that the manual states there is a combination of wave and osc1 mod settings that affects polyphony(page27). as for the waveshaper the manual does not indicate polyphony loss in that area ...

can someone reply so i know this is working?