Korg pa1xpro doesnt boot up since upgrade to version 3.0

BorisNezirovic · Post by **BorisNezirovic** » Mon Oct 15, 2007 6:56 am

Please if someone know what to do my pa1xpro doesnt boot up after upgrading to ver. 3.0. i have been removing the memory and trying something but doesnt work, somethimes boots but morethimes not.

wittid · Post by **wittid** » Mon Oct 15, 2007 7:48 am

Install OS again - if message come up - press "OK" then press the "INTRO1" button - then finish installation Disk 2,3,4

and then when message is coming remove disk4, switch off and reboot - should work.

explanation - with Intro1 you format the internal SSD-RAM - maybe there´s a little problem with that.

cu
Detlef

BorisNezirovic · Post by **BorisNezirovic** » Mon Oct 15, 2007 11:06 am

I did that its starrting to start it comes by the picture of pa1x and freeze. Doesnt boot,... could it be a memory related problem, i have done the reformating the os with the intro, after all doesnt boot...

wittid · Post by **wittid** » Mon Oct 15, 2007 11:11 am

hmmm, then i think you should contact your dealer

cu
Detlef

BorisNezirovic · Post by **BorisNezirovic** » Mon Oct 15, 2007 11:57 pm

Ok now is booting becouse i have changed to 2x32mb 72pin edo ram its working but if i load a set with pcm and samples its cracking that means memory is s**t,...sorry about my language, ill buy more memory and try,...Can someone answear me does pa1xpro s got same memory capicity like pa800,...32mb,...or can we fit more,...

wittid · Post by **wittid** » Tue Oct 16, 2007 6:49 am

only 2x16MB - and no Kb more

cu
Detlef

but - take for PA1X certificated RAMS - i had the problems i build some old rams i had at home in and they didn´t work correctly - permanent sample errors - krrrrrrrrrrrrrrrrrrrrrrrrrr - then bought 2 at a online-shop - specially for PA1X - perfect