Wobbly Knobs on a MicroKorg - repair?

CKsam · Post by **CKsam** » Mon Nov 19, 2007 5:45 pm

Hello all,

I've got a fairly old MicroKorg which has developed wobbly volume and cut-off knobs. Has anyone been in the same situation and managed a successful home repair? If so, could anyone give me a few handy hints so I don't make a hash of it.

Thanks, Sam

kpatz · Post by **kpatz** » Mon Nov 26, 2007 2:06 pm

Pull off the knob and check the shaft to see if it's loose. If it is, tighten the nut. If the shaft is tight, put a small piece of tape on top of the shaft and then push the knob back on. It should be tight after that.

CKsam · Post by **CKsam** » Thu Nov 29, 2007 11:46 am

Thanks for that. It's definitely the shaft that's loose, but as I recall the nut is on the inside, not the outside, isn't it? I'll have a look. I think I'll need to take off the top paneling.