Sampling problems - Triton ProX

[wyldkat]

I really could use some help from someone familiar with sampling on the ProX.

After recording the sample ok, on playback. the sample sounds slightly out of phase, and with a "popping or cracking" sound is heard along with the highest notes or words.
I have tried changing leads, mics, and even inputting direct thru a minidisc player all with the same results. Have also adjusted the recording frequency, as well as adjusting input levels, all to no avail.

If amyone has any suggestions, I would be most indebted to u.
thanks, Kat
[/b]

[Diego]

Hi!

Well, try to post that question on the "Triton Classic" section of that forum...
Maybe you can find some detailed help.
Lorenzo is a master on sampling with the Triton.


Regards

[Lorenzo]

master? ih ih ih
there are two things I can think about the problem:
1 bad looping point (but this doesn't explain the out of phase problem)
2 I had the exb08 with some bad ram module installed too and the rom sounds of the exb sounds with pop and crackle in the last octave of the triton... I had to remove the ram to make the sound play in the right way... but I thought this was just a ram problem affecting the exb and not the playback of ram samples.

can you post an mp3 with a sample of the problem? maybe three or four notes from the whole keyboard...

Regards, Lorenzo

[wyldkat]

Hiya Lorenza - aka Master ..... I will endeavor to get an mp3 file to you in the next couple of days, the Triton is set up in my other half's studio, but will be over there in the next day or so.

Its a real pain, as it is almost playing back out of phase, with every accentuated note being affected - thought it was also the analogue to digital convertor, or even a crossover problem. Not sure of the ram module would be the problem, as I dont have a problem with any other application (ie sequencer).

Thanks, will get back 2 u with that mp3 shortly,

Thanks, Kat