Hello, i put some PROGRAMS at the SEQUENCER mode, but the sound is different. For exemple, if I put in the sequencer mode the A111 sound, and i play it, the sound is diferent that de PROGRAM mode.
Why is different? How can i get the corerct sound?
Program Sounds in mode Sequencer at TR 76
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
That's because putting a program in the sequencer puts it there without the effects.
And that's because in program mode you have 3 effects for each program and in sequencer mode you have 3 effects for all the programs together (those are the numbers for Triton LE, but I believe it's the same with TR).
You have to do some FX routing there.
And that's because in program mode you have 3 effects for each program and in sequencer mode you have 3 effects for all the programs together (those are the numbers for Triton LE, but I believe it's the same with TR).
You have to do some FX routing there.
Hi Folks...
I too have the same problem. It's expecially obvious when selecting the drum kits in seq mode. They sound less 'fat' than they would when in program mode. Since someone earlier posted in to say it's got to do with the routing of the effects I guess we must read through the manual to understand how the effects routing and stuff is done.
If I manage to solve the problem, I will post the solution here. If one of you guys solve it, do share it too. Thanks.
regards
glisando
I too have the same problem. It's expecially obvious when selecting the drum kits in seq mode. They sound less 'fat' than they would when in program mode. Since someone earlier posted in to say it's got to do with the routing of the effects I guess we must read through the manual to understand how the effects routing and stuff is done.
If I manage to solve the problem, I will post the solution here. If one of you guys solve it, do share it too. Thanks.
regards
glisando
Hi!
After copying the IFX and MFX settings, it is also necessary to route the channel through the IFX. In the IFX setup all parts are routed to "L/R" outputs by default. Change this to "IFX" on part(s) which you want to route though IFX.
Because the effect processors are shared with all parts in the SEQ mode, it is not possible to have more than one part sounding exactly the same as in PROG mode. However, you can route more than one part through the IFX and also utilize send channels individually to MFX processors.
After copying the IFX and MFX settings, it is also necessary to route the channel through the IFX. In the IFX setup all parts are routed to "L/R" outputs by default. Change this to "IFX" on part(s) which you want to route though IFX.
Because the effect processors are shared with all parts in the SEQ mode, it is not possible to have more than one part sounding exactly the same as in PROG mode. However, you can route more than one part through the IFX and also utilize send channels individually to MFX processors.