Again Device inquiry error

MisterT · Post by **MisterT** » Fri Jun 27, 2008 11:54 am

Can anyone help me out please !!!!

I have it laptop connected to korg Radias
running win xp sp 2
running version 2 of korg firmware
version 2 of sound editor

and i am able to READ from KORG so i get the instruments
on sound editor in order for me to back it up..

But when i send data back to KORG i still get the
error "device inquiry error" so i cannot transmit to KORG Radias

Please if anyone knows the problem or answer let me know

Thanks in advance...

X-Trade · Post by **X-Trade** » Fri Jun 27, 2008 11:56 am

in preferences, MIDI IN should be set to RADIAS 1 KBD/KNOB
MIDI OUT should be set to RADIAS 1 SOUND.
Make sure your device isn't set to write protect.

I think device enquiry error is refering to the Radias not returning requests for data/etc e.g. not talking. If it doesn't work with the USB still, you could try re-starting... ir a different USB port.
I always make sure I run the Install KORG USB-MIDI Device application when turning the Radias on.

MisterT · Post by **MisterT** » Fri Jun 27, 2008 12:57 pm

Thanks X-Trade

That was the problem
Korg was set to memory write protect...

ilmeri · Post by **ilmeri** » Wed Jul 02, 2008 8:44 am

Device Inquiry error here as well... don't seem to get it to work no matter what i try.

I'm running the R3 on MBP and Duet, the R3 is connected to the MBP via USB, and midi is not an option because the Duet doesn't have one. I have installed the USB midi drivers from korg.

Anyway, the USB midi works as i can use it in cubase, the librarian software doesn't give any errors during startup and in the preferences the status of the MIDI IN / OUT changes to not connected if the R3 is not on. So it should work?

I have the sysex enabled, midi routing set to USB, protection set to off..is there more to be done?

I just hate this because i can't use in it's potential and just don't get it why it doesn't work. argh!

ilmeri · Post by **ilmeri** » Wed Jul 02, 2008 8:47 am

...and right after writing this message, for some unknown reason, it just started to work...i mean 3 months of nothing and then...

*knocking the wood*

slammah2012 · Post by **slammah2012** » Thu Jul 03, 2008 12:50 pm

ilmeri wrote:...and right after writing this message, for some unknown reason, it just started to work...i mean 3 months of nothing and then...

*knocking the wood*

Make sure you save it in your Global settings or else it will revert on power off.....