The state of my new but used microKontrol.
When I try to update I get as far as the firmware installer updater but it never installs the 1.03 file.
The updater driver installs then the firmware installer opens up but then yet again wants me to press setting, message exit (But this time suggests power is on?)
Either way its very very hard to get the firmware to install.
Can I do this on a mac will that make it take 1.03?
IS their any secret tips? I read over the forum for a long time.
After a while messing with it I get stuck at "Transmit error" in the firmware 1.02 to 1.03, however it does see the old version!
microKontrol firmware wont update.
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever