Extreme Combination Mode

unleashed_project · Post by **unleashed_project** » Fri May 07, 2010 5:57 pm

I am tryin to make a combi but combining a couple of programs i made. Ive had the triton classic before and it seemed to work the way i wanted. Now when i go into Bank E to make a combi, i can only here one sound on channel one, when i layer a another sound i dont here nothing. All of the other combis that the keyboard comes with seem to work fine anyone can help ?

X-Trade · Post by **X-Trade** » Fri May 07, 2010 6:11 pm

Have you checked that the timbre is on - i.e. set to 'INT' in the timbre parameters page, and that it is set to the global channel?

I think by default an initialised combi is set to with each timbre on a separate channel to make multitimbral setup easy.

unleashed_project · Post by **unleashed_project** » Fri May 07, 2010 6:15 pm

thanks but i just took a combi already made and added my programs to it, thanks for the quick reply i appreciate it

X-Trade · Post by **X-Trade** » Fri May 07, 2010 6:29 pm

It's also worth checking out the mixer levels (a bit obvious I know) and the output routings (FX Bus page)

BruceL · Post by **BruceL** » Sat May 08, 2010 3:11 am

the obvious is often overlooked. lol,

how about editing one of the other combies that work
to your desired preference then save it unto an empty
user slot unleashed_project.....

remyor · Post by **remyor** » Wed May 12, 2010 5:24 am

if the program is a moss, then you have to specify that.

unleashed_project · Post by **unleashed_project** » Sun May 23, 2010 5:21 pm

BruceL wrote:the obvious is often overlooked. lol,
how about editing one of the other combies that work
to your desired preference then save it unto an empty
user slot unleashed_project.....

thanks bro i got it working