Wondering if anyone can give me a tip on where to start with this. I'm trying to replicate the synth arpeggiator at the beginning of this song. Is this easy to do? http://www.youtube.com/watch?v=QiWn--cHtmY
Thank you
Need some help
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Two saw waves, equal volume.
Unison: 2 voices, spread to 100, or so.
Osc1 Mod: Waveform
Set LFO1 to S&H, MIDI sync to 16ths.
Adjust OSC1 Control 2 / LFO1 modulation to about 50 or more.
Adjust OSC1 Control 1 to taste.
Virtual Patch LFO1 to Osc2 level, somewhere between 25 to 40.
This should be pretty close.
Unison: 2 voices, spread to 100, or so.
Osc1 Mod: Waveform
Set LFO1 to S&H, MIDI sync to 16ths.
Adjust OSC1 Control 2 / LFO1 modulation to about 50 or more.
Adjust OSC1 Control 1 to taste.
Virtual Patch LFO1 to Osc2 level, somewhere between 25 to 40.
This should be pretty close.
Re: Need some help
Why not ask Jesus for help? I've heard that begging for answers tends to get you them. Unless of course you didn't deserve them in the first place.
If you want a serious answer, here's how you make the sound:
<iframe width="560" height="315" src="http://www.youtube.com/embed/NMF8F9z7Zr8" frameborder="0"></iframe>
Then you read the manual, then you spend a few months tweaking knobs and paying close attention to what each knob does.
If you want a serious answer, here's how you make the sound:
<iframe width="560" height="315" src="http://www.youtube.com/embed/NMF8F9z7Zr8" frameborder="0"></iframe>
Then you read the manual, then you spend a few months tweaking knobs and paying close attention to what each knob does.
Current: MS-20 Mini, Minilogue, SY77
Past: Korg R3, Volca Bass, X50, Mg Slim Phatty, Rld Gaia SH-01, Yamaha TX81Z
Have my freebie granular plug-in: https://www.muffwiggler.com/forum/viewt ... p?t=192886
Past: Korg R3, Volca Bass, X50, Mg Slim Phatty, Rld Gaia SH-01, Yamaha TX81Z
Have my freebie granular plug-in: https://www.muffwiggler.com/forum/viewt ... p?t=192886